Curado del revestimiento mediante el calentamiento del bloque de aluminio
  • Curado del revestimiento mediante el calentamiento del bloque de aluminio

Las fotos son solo para fines informativos. Ver especificaciones de producto

please use latin characters

Fabricante: Ambrell

Curado del revestimiento mediante el calentamiento del bloque de aluminio

Coating curing by heating the aluminum block


Objective: To heat an aluminum block for a cylinder liner coating curing application.


Equipment:

  • Ambrell EKOHEAT® 30 kW, 50-150 kHz solid state induction power supply with a workhead;
  • Single position four-turn helical coil.

Frequency: 89 kHz


Material: Aluminum block - 4" x 4" x 4.5" (102 x 102 x 114 mm)


Temperature: 400 °F (204 °C)


Testing: The aluminum part was placed inside the helical coil with temperature indicating paint applied to both the inside and outside of the block. The power was turned on and the part began to heat. After 90 seconds the temperature indicating paint began to melt.


Benefits:

  • Speed: The client’s oven had a heating time of 20 minutes, so the time savings are considerable with induction.
  • Precision and repeatability: Induction is a highly repeatable process, unlike an oven.
  • Floor space: Induction takes up less floor space than an oven.
Menos
Lee mas

Envíe una consulta

¿Estás interesado en este producto? ¿Necesita información adicional o precios individuales?

Contacta con nosotras
SOLICITA EL PRODUCTO close
Gracias por enviar tu mensaje. Responderemos lo antes posible.
SOLICITA EL PRODUCTO close
Vistazo
enviar una consulta

Añadir a la lista de deseos

Usted debe estar conectado

Coating curing by heating the aluminum block


Objective: To heat an aluminum block for a cylinder liner coating curing application.


Equipment:

  • Ambrell EKOHEAT® 30 kW, 50-150 kHz solid state induction power supply with a workhead;
  • Single position four-turn helical coil.

Frequency: 89 kHz


Material: Aluminum block - 4" x 4" x 4.5" (102 x 102 x 114 mm)


Temperature: 400 °F (204 °C)


Testing: The aluminum part was placed inside the helical coil with temperature indicating paint applied to both the inside and outside of the block. The power was turned on and the part began to heat. After 90 seconds the temperature indicating paint began to melt.


Benefits:

  • Speed: The client’s oven had a heating time of 20 minutes, so the time savings are considerable with induction.
  • Precision and repeatability: Induction is a highly repeatable process, unlike an oven.
  • Floor space: Induction takes up less floor space than an oven.
Menos
Lee mas
Comentarios (0)