Recocido de una muesca ovalada en un tubo de acero inoxidable antes de la extrusión
Recocido de una muesca ovalada en un tubo de acero inoxidable antes de la extrusión

Las fotos son solo para fines informativos. Ver especificaciones de producto

please use latin characters

Fabricante: Ambrell

Recocido de una muesca ovalada en un tubo de acero inoxidable antes de la extrusión

Anneal an oval cut out on a stainless steel tube prior to extrusion


Objective: To anneal a ¼” area around an oval cutout on a stainless steel tube prior to extrusion.


Frequency: 300 kHz


Equipment:
  • Ambrell 10kW induction heating system, equipped with a remote workhead containing one 1.0μF capacitor;
  • An induction heating coil designed and developed specifically for this application.

Material: .75” (19mm), 1.5” (38.1mm) and 4” (101.6mm) diameter steel tubes


Temperature: 1900 °F (1038 °C)


Process:

A single turn helical coil is used on the 4” (101.6mm) diameter tubes and a two turn helical coil is used on the smaller diameters. The coil is placed over the oval cutout and power is supplied for 15 seconds to anneal a 0.25" (6.35mm) diameter around the cutout.


Benefits:
  • Precise and controllable placement of heat to anneal only the required area
  • Faster process than flame
  • Repeatable results
  • Hands-free heating that involves no operator skill for manufacturing
Menos
Lee mas

Envíe una consulta

¿Estás interesado en este producto? ¿Necesita información adicional o precios individuales?

Contacta con nosotras
SOLICITA EL PRODUCTO close
Gracias por enviar tu mensaje. Responderemos lo antes posible.
SOLICITA EL PRODUCTO close
Vistazo
enviar una consulta

Añadir a la lista de deseos

Usted debe estar conectado

Anneal an oval cut out on a stainless steel tube prior to extrusion


Objective: To anneal a ¼” area around an oval cutout on a stainless steel tube prior to extrusion.


Frequency: 300 kHz


Equipment:
  • Ambrell 10kW induction heating system, equipped with a remote workhead containing one 1.0μF capacitor;
  • An induction heating coil designed and developed specifically for this application.

Material: .75” (19mm), 1.5” (38.1mm) and 4” (101.6mm) diameter steel tubes


Temperature: 1900 °F (1038 °C)


Process:

A single turn helical coil is used on the 4” (101.6mm) diameter tubes and a two turn helical coil is used on the smaller diameters. The coil is placed over the oval cutout and power is supplied for 15 seconds to anneal a 0.25" (6.35mm) diameter around the cutout.


Benefits:
  • Precise and controllable placement of heat to anneal only the required area
  • Faster process than flame
  • Repeatable results
  • Hands-free heating that involves no operator skill for manufacturing
Menos
Lee mas
Comentarios (0)
*/ -->