Formando la punta de teflón del catéter
  • Formando la punta de teflón del catéter

Las fotos son solo para fines informativos. Ver especificaciones de producto

please use latin characters

Formando la punta de teflón del catéter

Molding a Teflon Catheter Tip

Objective: Heat a water-cooled steel mandrel to 700°F (371ºC) to form a high quality Teflon catheter tip.

Material: Teflon catheter tubing, mandrel assembly

Temperature: 600-700°F (315.6-371ºC)

Frequency: 376 kHz

Equipment:

  • Ambrell 3 kW induction heating system, equipped with a remote workhead containing one 0.66μF capacitor
  • An induction heating coil designed and developed specifically for this application

Process: A two turn coil is used to heat the steel mandrel to 660ºF (371.1ºC) in 2.7 seconds. To form the catheter tip, RF power is applied while the catheter is held over the mandrel. The tubing is then pushed on to the mandrel to form a consistent, even tip.

Benefits:

  • Precise, repeatable application of heat
  • Non-contact heating
  • Faster cycle times

Menos
Lee mas

Envíe una consulta

¿Estás interesado en este producto? ¿Necesita información adicional o precios individuales?

Contacta con nosotras
SOLICITA EL PRODUCTO close
Gracias por enviar tu mensaje. Responderemos lo antes posible.
SOLICITA EL PRODUCTO close
Vistazo
enviar una consulta

Añadir a la lista de deseos

Usted debe estar conectado

Molding a Teflon Catheter Tip

Objective: Heat a water-cooled steel mandrel to 700°F (371ºC) to form a high quality Teflon catheter tip.

Material: Teflon catheter tubing, mandrel assembly

Temperature: 600-700°F (315.6-371ºC)

Frequency: 376 kHz

Equipment:

  • Ambrell 3 kW induction heating system, equipped with a remote workhead containing one 0.66μF capacitor
  • An induction heating coil designed and developed specifically for this application

Process: A two turn coil is used to heat the steel mandrel to 660ºF (371.1ºC) in 2.7 seconds. To form the catheter tip, RF power is applied while the catheter is held over the mandrel. The tubing is then pushed on to the mandrel to form a consistent, even tip.

Benefits:

  • Precise, repeatable application of heat
  • Non-contact heating
  • Faster cycle times

Menos
Lee mas
Comentarios (0)