Suformuojant kateterio tefloninį antgalį
  • Suformuojant kateterio tefloninį antgalį

Nuotraukos yra skirtos tik informaciniams tikslams. Peržiūrėkite produkto specifikaciją

please use latin characters

Suformuojant kateterio tefloninį antgalį

Molding a Teflon Catheter Tip

Objective: Heat a water-cooled steel mandrel to 700°F (371ºC) to form a high quality Teflon catheter tip.

Material: Teflon catheter tubing, mandrel assembly

Temperature: 600-700°F (315.6-371ºC)

Frequency: 376 kHz

Equipment:

  • Ambrell 3 kW induction heating system, equipped with a remote workhead containing one 0.66μF capacitor
  • An induction heating coil designed and developed specifically for this application

Process: A two turn coil is used to heat the steel mandrel to 660ºF (371.1ºC) in 2.7 seconds. To form the catheter tip, RF power is applied while the catheter is held over the mandrel. The tubing is then pushed on to the mandrel to form a consistent, even tip.

Benefits:

  • Precise, repeatable application of heat
  • Non-contact heating
  • Faster cycle times
mažiau
Skaityk daugiau

Atsiųskite užklausą

Ar Jūs domina šis produktas? Ar Jums reikia papildomos informacijos ar individualaus pasiūlymo?

Susisiekite su mumis
KLAUSKITE PRODUKTO close
Dėkojame, kad atsiuntėte žinutę. Atsakysime kuo greičiau.
KLAUSKITE PRODUKTO close
Naršyti
atsiųsti paklausimą

Pridėti į norų sąrašą

tu turi būti prisijungęs

Molding a Teflon Catheter Tip

Objective: Heat a water-cooled steel mandrel to 700°F (371ºC) to form a high quality Teflon catheter tip.

Material: Teflon catheter tubing, mandrel assembly

Temperature: 600-700°F (315.6-371ºC)

Frequency: 376 kHz

Equipment:

  • Ambrell 3 kW induction heating system, equipped with a remote workhead containing one 0.66μF capacitor
  • An induction heating coil designed and developed specifically for this application

Process: A two turn coil is used to heat the steel mandrel to 660ºF (371.1ºC) in 2.7 seconds. To form the catheter tip, RF power is applied while the catheter is held over the mandrel. The tubing is then pushed on to the mandrel to form a consistent, even tip.

Benefits:

  • Precise, repeatable application of heat
  • Non-contact heating
  • Faster cycle times
mažiau
Skaityk daugiau
Komentarai (0)