Lipirea componentelor din alamă pentru un producător de chiuvete
Lipirea componentelor din alamă pentru un producător de chiuvete

Fotografiile au doar scop informativ. Vizualizați specificațiile produsului

please use latin characters

Producător: Ambrell

Lipirea componentelor din alamă pentru un producător de chiuvete

Brazing Brass Assemblies for a Sink Manufacturer


Objective: To heat brass assemblies for a brazing application; the client had been using a torch and is a manufacturer of sink products.


Frequency: 316 kHz


Equipment:
  • Ambrell EASYHEAT™ 6 kW, 150-400 kHz solid state induction power supply with a workhead;
  • A coil specifically designed for this application.

Material: Brass assemblies (2”/51 mm OD)


Temperature: 1425 °F (773 °C)


Process:

A custom-designed single position multiple-turn helical coil was built to generate the required heating for the application. Initial tests were conducted to optimize the power delivered to the part. It took two minutes to heat the 2”/51 mm OD brass assembly to temperature.


Benefits:
  • Speed: Induction heated the assembly to temperature and met the client’s time requirements;
  • Repeatablility: The client can expect the same result in the same amount of time every single time, whereas with a torch they saw inconsistent quality that was highly dependent upon the operator;
  • Work Environment: With induction there is no open flame and with induction’s instant on/off capabilities, it introduces less heat into the work environment.
mai puțin
Citeste mai mult

Trimite o cerere

Sunteți interesat de acest produs? Aveți nevoie de informații suplimentare sau de prețuri individuale?

Contactează-ne
CERETI PRODUSUL close
Vă mulțumim că ați trimis mesajul dvs. Vom răspunde cât mai curând posibil.
CERETI PRODUSUL close
Naviga
trimite o anchetă

Adaugă la lista de dorințe

trebuie să fii logat

Brazing Brass Assemblies for a Sink Manufacturer


Objective: To heat brass assemblies for a brazing application; the client had been using a torch and is a manufacturer of sink products.


Frequency: 316 kHz


Equipment:
  • Ambrell EASYHEAT™ 6 kW, 150-400 kHz solid state induction power supply with a workhead;
  • A coil specifically designed for this application.

Material: Brass assemblies (2”/51 mm OD)


Temperature: 1425 °F (773 °C)


Process:

A custom-designed single position multiple-turn helical coil was built to generate the required heating for the application. Initial tests were conducted to optimize the power delivered to the part. It took two minutes to heat the 2”/51 mm OD brass assembly to temperature.


Benefits:
  • Speed: Induction heated the assembly to temperature and met the client’s time requirements;
  • Repeatablility: The client can expect the same result in the same amount of time every single time, whereas with a torch they saw inconsistent quality that was highly dependent upon the operator;
  • Work Environment: With induction there is no open flame and with induction’s instant on/off capabilities, it introduces less heat into the work environment.
mai puțin
Citeste mai mult
Comentarii (0)