![Зарядное устройство для батареи батареи батареи синего батареи Victron Energy Power IP67 Зарядное устройство для батареи батареи батареи синего батареи Victron Energy Power IP67](https://www.dacpol.eu/8209-large_default/victron-energy-blue-power-battery-charger-ip67.jpg)
![Зарядное устройство для батареи батареи батареи синего батареи Victron Energy Power IP67 Зарядное устройство для батареи батареи батареи синего батареи Victron Energy Power IP67](https://www.dacpol.eu/8209-large_default/victron-energy-blue-power-battery-charger-ip67.jpg)
Category
Montaż urządzeń
Modernizacja induktorów
Urządzenia indukcyjne
asd
Фотографии предназначены только для информационных целей. Посмотреть спецификацию продукта
please use latin characters
Microprocessor controlled Blue Power Charger
Completely encapsulated: waterproof, shockproof and ignition protected
Water, oil or dirt will not damage the Blue Power IP67 Charger. The casing is made of cast aluminium and the electronics are moulded in resin.
Start interrupt
The models with suffix (1+Si) feature a second current limited output which is always powered as long as 180 – 265 VAC is present on the input. This output can for example be used to prevent starting of a vehicle before unplugging the battery charger (start interrupt function).
The highest efficiency ever!
Setting a new industry standard: with 92% efficiency or better, these chargers waste three to four times less heat.
And once the battery is fully charged, power consumption reduces to less than a Watt, some five to ten times better than the industry standard.
Adaptive 4-stage charge algorithm: bulk – absorption – float – storage
The Blue Power Charger features a microprocessor controlled ‘adaptive’ battery management. The ‘adaptive’ feature will automatically optimise the charging process relative to the way the battery is being used.
Less maintenance and aging when the battery is not in use: the Storage Mode
The storage mode kicks in whenever the battery has not been subjected to discharge during 24 hours. In the storage mode float voltage is reduced to 2,2 V/cell (13,2 V for a 12 V battery) to minimise gassing and corrosion of the positive plates. Once a week the voltage is raised back to the absorption level to ‘equalize’ the battery. This feature prevents stratification of the electrolyte and sulphation, a major cause of early battery failure.
Protected against overheating
Can be used in a hot environment such as a machine room. Output current will reduce as temperature increases up to 60°C, but the charger will not fail.
Two LEDs for status indication
Yellow LED: bulk charge (blinking fast), absorption (blinking slow), float (solid), storage (off)
Green LED: power on
Blue Power charger IP67 |
Blue Power
|
Blue Power
|
Blue Power
|
Blue Power
|
Blue Power
|
Blue Power
|
Blue Power
|
---|---|---|---|---|---|---|---|
Input voltage range and frequency | 180-265 VAC 45-65 Hz | ||||||
Efficiency | 93% | 93% | 95% | 95% | 94% | 96% | 96% |
No load power consumption (W) | 0.5 | 0.5 | 0.5 | 0.5 | 0.5 | 0.5 | 0.5 |
Charge voltage 'absorption' (V DC) | 14,4 | 14,4 | 14,4 | 14,4 | 28,8 | 28,8 | 28,8 |
Charge voltage 'float' (V DC) | 13,7 | 13,7 | 13,7 | 13,7 | 27,6 | 27,6 | 27,6 |
Charge voltage 'storage' (V DC) | 13,2 | 13,2 | 13,2 | 13,2 | 26,4 | 26,4 | 26,4 |
Charge current (A) | 7 | 13 | 17 | 25 | 5 | 8 | 12 |
Charge algorithm | 4-stage adaptive | ||||||
Can be used as power supply | yes | ||||||
Protection | Battery reverse polarity (fuse) Output short circuit Over temperature | ||||||
Operating temp. range | -20 to +60°C (full rated output up to 40°C) | ||||||
Humidity | Up to 100% | ||||||
Start interrupt option (Si) | Short circuit proof, current limit 0,5 A Output voltage: max one volt lower than main output | ||||||
ENCLOSURE | |||||||
Material [&] Colour | aluminium (blue RAL 5012) | ||||||
Battery-connection | Black and red cable of 1,5 meter | ||||||
230 V AC-connection | Cable of 1,5 meter with CEE 7/7 plug | ||||||
Protection category | IP67 | ||||||
Weight (kg) | 1,8 | 1,8 | 2,4 | 2,4 | 1,8 | 2,4 | 2,4 |
Dimensions (h x w x d in mm) | 85 x 211 x 60 | 85 x 211 x 60 | 99 x 219 x 65 | 99 x 219 x 65 | 85 x 211 x 60 | 99 x 219 x 65 | 99 x 219 x 65 |
STAINDARDS | |||||||
Safety | EN 60335-1, EN 60335-2-29 | ||||||
Emission Immunity | EN 55014-1, EN 61000-6-3, EN 61000-3-2 | ||||||
Automotive Directive | EN 55014-2, EN 61000-6-1, EN 61000-6-2, EN 61000-3-3 |
Вы заинтересованы в этом продукте? Вам нужна дополнительная информация или индивидуальные расценки?
Вы должны быть зарегистрированы
Microprocessor controlled Blue Power Charger
Completely encapsulated: waterproof, shockproof and ignition protected
Water, oil or dirt will not damage the Blue Power IP67 Charger. The casing is made of cast aluminium and the electronics are moulded in resin.
Start interrupt
The models with suffix (1+Si) feature a second current limited output which is always powered as long as 180 – 265 VAC is present on the input. This output can for example be used to prevent starting of a vehicle before unplugging the battery charger (start interrupt function).
The highest efficiency ever!
Setting a new industry standard: with 92% efficiency or better, these chargers waste three to four times less heat.
And once the battery is fully charged, power consumption reduces to less than a Watt, some five to ten times better than the industry standard.
Adaptive 4-stage charge algorithm: bulk – absorption – float – storage
The Blue Power Charger features a microprocessor controlled ‘adaptive’ battery management. The ‘adaptive’ feature will automatically optimise the charging process relative to the way the battery is being used.
Less maintenance and aging when the battery is not in use: the Storage Mode
The storage mode kicks in whenever the battery has not been subjected to discharge during 24 hours. In the storage mode float voltage is reduced to 2,2 V/cell (13,2 V for a 12 V battery) to minimise gassing and corrosion of the positive plates. Once a week the voltage is raised back to the absorption level to ‘equalize’ the battery. This feature prevents stratification of the electrolyte and sulphation, a major cause of early battery failure.
Protected against overheating
Can be used in a hot environment such as a machine room. Output current will reduce as temperature increases up to 60°C, but the charger will not fail.
Two LEDs for status indication
Yellow LED: bulk charge (blinking fast), absorption (blinking slow), float (solid), storage (off)
Green LED: power on
Blue Power charger IP67 |
Blue Power
|
Blue Power
|
Blue Power
|
Blue Power
|
Blue Power
|
Blue Power
|
Blue Power
|
---|---|---|---|---|---|---|---|
Input voltage range and frequency | 180-265 VAC 45-65 Hz | ||||||
Efficiency | 93% | 93% | 95% | 95% | 94% | 96% | 96% |
No load power consumption (W) | 0.5 | 0.5 | 0.5 | 0.5 | 0.5 | 0.5 | 0.5 |
Charge voltage 'absorption' (V DC) | 14,4 | 14,4 | 14,4 | 14,4 | 28,8 | 28,8 | 28,8 |
Charge voltage 'float' (V DC) | 13,7 | 13,7 | 13,7 | 13,7 | 27,6 | 27,6 | 27,6 |
Charge voltage 'storage' (V DC) | 13,2 | 13,2 | 13,2 | 13,2 | 26,4 | 26,4 | 26,4 |
Charge current (A) | 7 | 13 | 17 | 25 | 5 | 8 | 12 |
Charge algorithm | 4-stage adaptive | ||||||
Can be used as power supply | yes | ||||||
Protection | Battery reverse polarity (fuse) Output short circuit Over temperature | ||||||
Operating temp. range | -20 to +60°C (full rated output up to 40°C) | ||||||
Humidity | Up to 100% | ||||||
Start interrupt option (Si) | Short circuit proof, current limit 0,5 A Output voltage: max one volt lower than main output | ||||||
ENCLOSURE | |||||||
Material [&] Colour | aluminium (blue RAL 5012) | ||||||
Battery-connection | Black and red cable of 1,5 meter | ||||||
230 V AC-connection | Cable of 1,5 meter with CEE 7/7 plug | ||||||
Protection category | IP67 | ||||||
Weight (kg) | 1,8 | 1,8 | 2,4 | 2,4 | 1,8 | 2,4 | 2,4 |
Dimensions (h x w x d in mm) | 85 x 211 x 60 | 85 x 211 x 60 | 99 x 219 x 65 | 99 x 219 x 65 | 85 x 211 x 60 | 99 x 219 x 65 | 99 x 219 x 65 |
STAINDARDS | |||||||
Safety | EN 60335-1, EN 60335-2-29 | ||||||
Emission Immunity | EN 55014-1, EN 61000-6-3, EN 61000-3-2 | ||||||
Automotive Directive | EN 55014-2, EN 61000-6-1, EN 61000-6-2, EN 61000-3-3 |
Не удаётся отправить вашу оценку отзыва
Пожаловаться на комментарий
Жалоба отправлена
Не удаётся отправить вашу жалобу
Оставьте свой отзыв
Отзыв отправлен
Не удаётся отправить отзыв